SARS-CoV-2 Antigen Test Kit(Immunofluorescence)
Product Information
Keywords | SARS-CoV-2 Antigen Test Kit(Immunofluorescence) |
Main Composition | Test Cassette individually foil pouched with a desiccant, Sample
Tube, with cap and antigen extraction buffer,Sampling swab,
Instruction for use |
Sampling | Nasopharyngeal (NP) and Nasal swab,Saliva,Oropharyngeal (OP) swab |
Usage/ | Qualitative detection of the nucleocapsid protein antigen from
SARS-CoV-2 in nasopharyngeal (NP), nasal swab and saliva specimens |
Package | 10 Test/Kit |
Brand | KISSH |
Shelf-life | 12 months |
Test procedure
Perform the test only when the reagent has equilibrated to room
temperature (18 ℃~26 ℃ ) to avoid affecting the accuracy of the
experimental results.
1. Instrument preparation: ① Turn on the power of the fluorescence
analyzer, select the detection mode (quick test/standard test); ②
Read the reagent ID chip; ③ Select the sample type and test items;
④ The specific operation of the instrument is performed in
accordance with the instruction manual of the corresponding model
instrument.
2. Take the sample to be tested and the required reagents out of
storage conditions and equilibrate to room temperature.
3. Unpack the aluminum foil pouch, place the test card horizontally
on the table and mark it.
4. Place the sample tube on the workbench.Insert the collected swab
into the sample tube,rotate the swab for about 10 seconds, and
press the swab head against the tube wall to release antigen in the
swab. Squeeze the swab over the head to remove the swab so as to
remove as much liquid as possible from the swab. Dispose of swabs
according to biohazard wasted disposal method.
5. Install the dropper cap onto the smaple tube, put two drops
ofthe extraction solution into the sample well and startt he timer.
6.Test
① Standard test:
After the sample is added, insert the test card into the instrument
and click “start test”. The instrument automatically counts the
time. After the reaction countdown of 15 minutes is over, the
instrument automatically performs the test, and records, reads and
prints the test results.
② Quick test:
After adding the sample, time 15 minutes with a timer. When the
time is up, insert the test card into the instrument, and click
"Start Test". The instrument automatically performs the test, and
records, reads and prints the test results.
If the test card fails to be tested in time within 15~20 minutes,
it will be deemed as invalid test, and the sample need to be
retested with a new test card.
